Transaxle Removal And Installation - Toro Workman 3000 Series Service Manual

Transaxle Removal and Installation

Transaxle Removal
1. Put machine on a level surface. Stop the engine and
remove key from ignition switch. Remove the bed or oth ­
er attachment(s). Allow engine and radiator to cool.
2. Disconnect positive (+) and negative (–) battery
cables from battery.
3. Remove drain plug from bottom of transaxle and allow
oil to drain into a drain pan. Install drain plug.
4. Note orientation of hydraulic hose and 90� fitting con­
nected to strainer on side of reservoir. Remove hydraulic
hose and 90� fitting. (NOTE: Workman 3300–D has a
steel tube line instead of a hose.)
Workman 3000/4000 Series
1
Page 6 – 17
Figure 27
1. Drain plug
1
Figure 28
1. Strainer
Drive Train