Toro Workman 3000 Series Service Manual page 94

Water Pump Installation
Bolts used to secure water pump are different sizes.
Make sure different size bolts are installed in the correct
locations. Tighten bolts evenly to a torque of 8 – 10 Nm
(6 – 7 ft–lb).
Water Pipe Installation
Fit water pipe O–ring in groove provided at water pipe
end as shown in illustration. Wet outer diameter of O–
ring with anti–freeze before inserting water pipe.
IMPORTANT: DO NOT apply oil or grease to water
pipe O–ring. Keep water pipe connections free of
sand, dust, dirt, etc. Insert water pipe until end bot­
toms.
Liquid Cooled Gas Engine
6 x 35
(.24 x 1.38)
Page 3 – 56
Thread diameter
x length mm (in.)
6 x 18
(.24 x .71)
Figure 94
Figure 95
Workman 3000/4000 Series