Toro Workman 3000 Series Service Manual page 295

5. Remove PTO drive shaft:
C. Shift PTO to "ON" position.
D. Remove 2 snap rings (Item 1, 2) from PTO case.
E. Slide drive shaft assembly (Item 3) toward PTO
shaft side.
F. Remove bearing (Item 4).
G. Slide drive shaft toward other side.
H. Remove bearing (Item 5).
I. Remove washer (Item 6) and gear (Item 7), sliding
drive shaft toward PTO shaft side.
J. Release shift arm (Item 8) from block (Item 9).
K. Remove drive shaft assembly.
6. Disassemble PTO drive shaft:
A. Remove shifter (Item 1).
B. Remove 2 steel balls (Item 2) and spring (Item 3).
Workman 3000/4000 Series
1
Page 6 – 57
Figure 137
8
6
3
7
Figure 138
2
3
Figure 139
Drive Train