Repairs; Repairs - Toro Workman 3000 Series Service Manual

Repairs

Shifter Cable Replacement
7
NOTE: Before removing cable(s), note routing and loca-
tion of cable ties.
1. Before installing cables adjust clevis (Item 1) on 1st–
Rev and 2nd–3rd cables as shown Figure 18.
2. Connect shift cables to shift links (Item 6) on shifter in
operator platform by inserting both clevis pins (Item 5)
from the passenger side, then install cotter pins.
3. Securely fasten cables to shifter bracket with clamp
(Item 3).
4. Spread jam nuts (Item 7) on bulkhead fittings of cable.
With cable properly routed to transaxle, install cable
bulkhead fitting to cable bracket on transaxle and tighten
jam nuts.
5. Install cable ties in the original locations.
6. Do cable adjustments.
Drive Train
4
20 – 24 Nm
(15 – 18 ft–lb)
2nd–3rd
High–Low
First–Rev
d
6
3
Figure 17
3
1. Clevis
2. Shift cable
Page 6 – 12
5
2
1
5
9
10
9.5 mm (.375 in.)
2
1
Figure 18
3. Clamp
4. Shift stop bolt
Workman 3000/4000 Series
2
1
6
4