Toro Workman 3000 Series Service Manual page 327

Installation
1. Before installing new leaf spring, insert four (4) rubber
bushings (Item 11) into leaf spring. Insert two (2) rubber
bushings into frame side rail.
2. Insert one (1) spring shackle (Item 11), from outside/
in, into rear of leaf spring. Insert spring mount (Item 10),
from outside/in, to front of leaf spring and secure, finger
tight, with locknut. NOTE: Clip is on front end of spring.
3. Install leaf spring assembly to frame. Secure front
spring mount (Item 10) with flange head capscrews
(Item 9 and locknuts (Item 8) and tighten finger tight.
Install locknuts (Item 6) to spring shackles (Item 7) and
tighten finger tight. Tighten locknuts (Item 6). Leave
flange locknuts (Item 8), securing spring mount to frame
rail, finger tight.
4. Install plate (Item 5) to top of spring, then secure axle
to spring with carriage bolts (Item 3), washers (Item 2)
and locknuts (Item 1). NOTE: Make sure axle (Item 4)
and plate (Item 5) are centered on leaf spring knob.
5. Tighten nuts (Item 1) in a crossing pattern until clamp
plate, leaf spring and axle contact. Tighten flange lock ­
nuts (Item 8) securing spring mount to frame rail. Tight­
en nuts (Item 1) securing axle and clamp plate to leaf
spring using a crossing pattern and the following torque
values:
A. Tighten nuts to 20 – 30 ft–lb (27 – 41 Nm) in a
crossing pattern.
B. Tighten nuts to 50 – 60 ft–lb (68 – 81 Nm) in a
crossing pattern.
C. Retighten nuts to 50 – 60 ft–lb (68 – 81 Nm).
Workman 3000 Series
Make sure axle and
plate are centered
on leaf spring knob
Page 7 – 25
Clip is on front
end of spring
Figure 29
Steering, Brakes and Supension