Toro Workman 3000 Series Service Manual page 286

IMPORTANT:On early versions of the center plate,
use one thick, tabbed shim (Item 2) (Fig. 111).
22. Insert shim (Item 2) against the bearing. Use thick-
est shim possible that will permit installation of the snap
ring. (Fig. 111 and 113).
IMPORTANT:On newer versions of the center plate,
use one tabbed shim (Item 4) with three tabless
shims (Item 2) (Fig. 112).
Note: The thickest shim of the shim set (Item 2) should
be positioned against the snap ring (Fig. 112).
23. Insert tabbed shim (Item 4) against the bearing. In-
sert shim set (Item 2) against the tabbed shim. Use
thickest shims in set possible, that will permit installation
of the snap ring. (Fig. 112 and 113).
24. Install snap ring into the groove of the bearing hous­
ing (Fig. 113 and 114).
Drive Train
3
1
3
6
4
1. Countershaft
2. Bearing
3. Shims
Page 6 – 48 Rev. D
2
Figure 111
Figure 112
5
1
2
Figure 113
4. Snap ring
5. Center plate
6. Sealing cap
Figure 114
Workmand 3000 /4000 Series
4
2