19. Install reverse shaft (Item 1). Rotate main shaft and
reverse shaft gears to mesh gears when installing.
20. On 4WD units, install bearing to gear case and cen
ter plate. Install front drive shaft and 41T gear to the gear
case (see Item 2 of Fig. 103).
21. Install center plate:
A. Insert 2 dowel pins into transaxle case.
B. Apply silicone sealant onto mating surface of
center plate.
C. Tighten capscrews to a torque of 24.5 – 29.5 Nm
(18.5 – 22 ft–lb).
D. Apply multi–purpose grease onto lips of oil seal,
then insert oil seal flush with face of housing.
E. Apply moly disulfide grease to spline of main
shaft for clutch disk hub.
Workman 3000/4000 Series
41T GEAR
Page 6 – 47 Rev. B
1
Figure 108
FRONT DRIVE
SHAFT
BEARING
(GEAR CASE)
BEARING
(CENTER PLATE)
Figure 109
Figure 110
Drive Train
2