Toro Workman 3000 Series Service Manual page 321

Front Shock Absorber Replacement
1. Remove lower and upper locknuts, then remove
shock absorber and washers.
2. Insert two (2) new rubber bushings (Item 1) into each
end of new shock absorber. Insert spacer (Item 2) into
ram (lower) end of shock absorber.
3. Install large washer (Item 3) onto stud above control
arm.
4. Install new shock absorber (Item 4) with ram end
down and secure upper end with small flat washer (Item
5) and locknut (Item 6).
5. Insert capscrew (Item 7) down through angled hole in
shock stand. Install washer (Item 8) onto capscrew and
slide shock absorber onto capscrew. Install second
washer (Item 9) onto capscrew and secure with locknut
(Item 10).
Workman 3000 Series
5
1
3
10
Shock absorber
Page 7 – 19
7
6
4
8
2
1
9
Figure 19
Figure 20
Steering, Brakes and Supension