Special Tools
Order special tools from the TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS).
Continuity Tester
Battery powered test lamp which is helpful in testing for
continuity of circuits and electrical components when the
current is off.
Multimeter
The meter can test electrical components and circuits for
current, resistance, or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt–
Ohm–Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Skin–Over Grease
Special non–conductive grease (Toro Part No. 505–47)
which forms a light protective skin which helps water-
proof electrical switches and contacts.
Workman 3000/4000 Series
Some tools may also be available from a local supplier.
Page 8 – 13
Figure 1
Figure 2
Figure 3
Electrical System (Rev. G)