Toro Workman 3000 Series Service Manual page 257

16. Block front wheels. Jack–up rear of machine under
rear axle and install jack stands so transaxle can be re ­
moved by sliding out under rear axle.
17. Put blocking under engine for support. Support
transaxle with a floor jack or suspend transaxle from
vehicle frame rails. NOTE: PTO hole cover has a
threaded boss where you can attach a bracket or ring for
2
supporting the transaxle.
18. Remove transaxle isolation mounts and mount
brackets.
1
1
19. Remove drive shaft clamp bolts, then slide transaxle
side–to–side to disconnect each drive shaft from axle
Figure 30
shafts on transaxle.
1. Jacking points 2. Mount brackets
20. Remove capscrews securing clutch bell housing to
engine. Remove capscrews securing clutch cover to bell
housing (Workman 3200).
21. Carefully pull transaxle back to disengage transaxle
input shaft from clutch. Use floor jack to lower transaxle
and slide out rear of machine under the frame.
Transaxle Installation
1. To install the transaxle, perform Transaxle Removal
procedure in reverse order.
IMPORTANT: Workman 3100 (air cooled gas) ma­
chines require application of silicone sealant to gap
between bell housing and engine on right side of
bell housing. This will prevent dirt and debris from
getting into bell housing and damaging clutch or re­
lease bearing.
2. Install a new hydraulic oil filter and fill transaxle with
the correct oil (see Chapter 9 – Hydraulic System).
Check for oil leaks and repair as necessary.
3. Adjust clutch pedal, shift cables, high–low cable, dif­
ferential lock cable and PTO cable.
Workman 3000/4000 Series Page 6 – 19 Drive Train