Rear Shock Absorber Replacement - Toro Workman 3000 Series Service Manual

Rear Shock Absorber Replacement

1. Remove lower and upper locknuts, then remove
shock absorber and washers.
2. Insert two (2) new rubber bushings (Item 1) into each
end of new shock absorber.
3. Install one large washer (Item 2) onto each shock ab­
sorber mounting stud.
4. Install new shock absorber (Item 3) with ram end
down and secure each end with with a large washer
(Item 4) and locknut (Item 5).
Steering, Brakes and Suspension
1. Rubber bushing
2. Large washer
3. Shock absorber
Page 7 – 20
2
3
2
4
1
Figure 21
4. Large washer
5. Locknut
Shock absorber
Figure 22
Workman 3000 Series
1
4
5
5