Toro Workman 3000 Series Service Manual page 256

2
1. PTO
2. Drive shaft coupler
5. Remove muffler.
6. Remove hydraulic filter assembly and bracket.
7. Remove starter assembly from bell housing (Work­
man 3200 only).
8. Disconnect and label electrical leads that attach to
transaxle and PTO.
9. Disconnect clutch cable from clutch release lever,
then loosen jam nut to remove cable from support
bracket (see Clutch Pedal Adjustment).
10. On units with the differential lock lever installed,
loosen jam nut to remove cable from support bracket,
then disconnect differential lock cable from lever at left
rear of transaxle (see Differential Lock Cable Adjust­
ment).
Drive Train
3
Figure 29
(Workman 3200 shown)
3. Control cable support bracket
4. Drive shaft assembly
11. Disconnect shifter control cables from levers on
transaxle and PTO (see Shift Cable Adjustment). Do not
loosen jam nuts to remove cables from support bracket.
12. Remove control cable support bracket, keeping
shifter control cables attached to bracket.
13. Remove differential drive shaft, bidirectional clutch,
and adapter plate from the transaxle (see Bidirectional
Clutch Removal in Chapter 10 – Front Wheel Drive Sec­
tion (4WD)).
14. Disconnect hydraulic hoses from transaxle and
PTO. Put labels on hydraulic hoses for proper reas­
sembly. Put caps or plugs on all open hoses or fittings to
prevent contamination. Label hoses and fittings for prop ­
er reinstallation.
15. Remove PTO, if equipped, from top of transaxle (see
PTO Removal and Installation).
Page 6 – 18 Rev. D
4
1
5
4
5. Mount bracket
Workman 3000/4000 Series