Bleeding The Brakes - Toro Workman 3000 Series Service Manual

Bleeding the Brakes

1. Connect a suitable transparent hose to bleeder valve
on right rear wheel cylinder and submerge other end in
a glass container partially filled with clean brake fluid.
2. Have a helper pump brake pedal several times, then
hold pedal down firmly.
3. With pedal firmly depressed, open bleeder valve of
right rear brake until pedal fades to floor, then close
Bleeder valve
bleeder valve.
4. Repeat procedure until a continuous flow of brake
fluid, with no air bubbles, is released from bleeder valve.
Make sure fluid level is maintained in brake fluid res-
ervoir at all times.
5. Do steps 1 – 4 for left rear, right front and left front
Figure 11
brakes.
6. After bleeding of brakes is completed, road test ve-
hicle to make sure brakes are operating correctly and
pedal is solid.
Workman 3000 Series Page 7 – 15 Steering, Brakes and Supension