Toro Workman 3000 Series Service Manual page 88

Camshaft Sprocket Removal
1. Prevent camshaft from turning and remove camshaft
sprocket bolt.
Oil Pump Sprocket Removal
1. Remove plug on left side of cylinder block and insert
a 8 mm (.31 in.) diameter rod to lock counterbalance
shaft.
2. Remove oil pump sprocket flange nut.
Crankshaft Bolt Removal
1. Use special tool to prevent flywheel from turning and
remove crankshaft bolt.
Liquid Cooled Gas Engine
End yoke
holder tool
MB990767
Page 3 – 50
Figure 75
Oil pump sprocket
Rod
Figure 76
Flywheel
Figure 77
Workman 3000/4000 Series