Siemens SINUMERIK 840D sl Programming Manual page 468

Tool offsets
7.4 Online tool offset (PUTFTOCF, FCTDEF, PUTFTOC, FTOCON, FTOCOF)
PUTFTOCF:
PUTFTOC:
468
Call the "Continuous non-modal write of online tool offset" function
Parameter:
<function>:
<reference value>:
<tool parameter:
<channel>:
<spindle>:
Call the "Discrete write of online tool offset" function.
Parameter:
<offset value>:
<tool parameter>:
<channel>:
<spindle>:
Number of the polynomial function
Type: INT
Note:
Must match the setting for FCTDEF.
Variable reference value from which the offset is
to be derived (e.g. changing actual value).
Type: VAR REAL
Number of the wear parameter (length 1, 2 or 3)
in which the offset value is to be added.
Type: INT
Number of the channel in which the online tool
offset is to take effect.
Type: INT
Note:
A channel number only has to be specified if the
offset is not to take effect in the active channel.
Number of the spindle for which the online tool
offset is to take effect.
Type: INT
Note:
A spindle number only has to be specified if the
offset is to be applied to a non-active grinding
wheel rather than the active tool which is
currently in use.
Offset value to be added in the wear parameter.
Type: REAL
See PUTFTOCF
Number of the channel in which the online tool
offset is to take effect.
Type: INT
See PUTFTOCF
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Job Planning