Siemens SINUMERIK 840D sl Programming Manual page 51

<value>:
<number_array_elements>:
Job Planning
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Value, which the array elements should be written
when initializing with REP.
Number of array elements to be written with the
specified <value>. The following apply to the
remaining array elements, dependent on the point in
time:
• initialization when defining the array:
→ Zero is written to the remaining array elements.
• Assignment during program execution:
→ The actual values of the array elements remain
unchanged.
If the parameter is not programmed, all array
elements are written with <value>.
If the parameter equals zero, the following apply
dependent on the point in time:
• initializing when defining the array:
→ All elements are pre-assigned zero
• Assignment during program execution:
→ The actual values of the array elements remain
unchanged.
Flexible NC programming
1.1 Variables
51