Siemens SINUMERIK 840D sl Programming Manual page 598

Axis couplings
9.2 Curve tables (CTAB)
CTABPOLID
CTABPOL
CTABFPOL
CTABMPOL
<n>
<memory
location>
<segment type>
598
Determine the number of curve polynomials used by curve table
number <n>
Determine the number of curve polynomials used in the specified
<memory location>
Determine the number of curve polynomials remaining possible in
the specified <memory location>
Determine the maximum possible number of curve polynomials in
the specified <memory location>
Number (ID) of curve table
Specification of memory location (optional)
"SRAM"
Static NC memory
"DRAM"
Dynamic NC memory
Note:
If a value is not programmed for this parameter, the default memory
location set with
MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE is used.
Specification of segment type (optional)
"L"
Linear segments
"P"
Polynomial segments
Note:
If no value is programmed for this parameter, the sum of the linear
and polynomial segments is output.
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Job Planning