Siemens SINUMERIK 840D sl Programming Manual page 567

ATOL
Note
CTOL and OTOL have priority over ATOL.
General conditions
Scaling frames
Scaling frames affect programmed tolerances in the same way as axis positions; in other
words, the relative tolerance remains the same.
Job Planning
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
8.8 Programmable contour/orientation tolerance (CTOL, OTOL, ATOL)
Command for programming an axis-specific tolerance
ATOL is valid for:
• All compressor functions
• ORISON orientation smoothing
• All rounding types except G641, G644, OSD
Name of the axis for which an axis tolerance is to be programmed
<axis>:
The value for the axis tolerance will be specified as a length or an
<value>:
angle dependent on the axis type (linear or rotary axis).
Type:
Unit:
REAL
for linear axes: inch/mm (dependent on the
current dimensions setting)
for rotary axes: degrees
Path traversing behavior
567