Master/Slave Group (Masldef, Masldel, Maslon, Maslof, Maslofs) - Siemens SINUMERIK 840D sl Programming Manual

9.6 Master/slave group (MASLDEF, MASLDEL, MASLON, MASLOF,
9.6 MASLOFS)
Function
The master/slave coupling in SW 6.4 and lower permitted coupling of the slave axes to their
master axis only while the axes involved are stopped.
Extension of SW 6.5 permits coupling and uncoupling of rotating, speed-controlled spindles
and dynamic configuration.
Syntax
MASLON(Slv1,Slv2,..., )
MASLOF(Slv1,Slv2,..., )
MASLDEF(Slv1,Slv2,..., master axis)
MASLDEL(Slv1,Slv2,..., )
MASLOFS(Slv1, Slv2, ..., )
Note
For MASLOF/MASLOFS, the implicit preprocessing stop is not required. Because of the
missing preprocessing stop, the $P system variables for the slave axes do not provide
updated values until next programming.
Significance
General
MASLON
MASLOF
Job Planning
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0

9.6 Master/slave group (MASLDEF, MASLDEL, MASLON, MASLOF, MASLOFS)

Close (switch-in) a temporary coupling.
Open an active coupling. The extensions for spindles must be
observed.
Extension for dynamic configuration
Extension for dynamic configuring
extension
Extension for slave spindle
Axis couplings
629