Mounting Positions Of Motor-Integrated Servo Drives; Compatibility With Foreign Matters; Motor Paint; Voltage Testing And Insulation Resistance Testing - Bosch rexroth IndraDrive Mi KCU02 Project Planning Manual

IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03

Mounting positions of motor-integrated servo drives

4.3.4

Compatibility with foreign matters

4.3.5

Motor paint

4.4

Voltage testing and insulation resistance testing

IM B5
Flange mounting on drive
side of flange
The drive electronics of a
motor-integrated servo
drive can be oriented as
desired.
Tab. 4-13: Allowed types of installation according to EN 60034-7:1993
NOTICE
If fluid is present at the output shaft over a prolonged time in mounting
position IM V3, the fluid may enter the housing and cause damage.
Ensure that fluid cannot be present at the output shaft.
All Rexroth controls and drives are developed and tested according to the
state-of-the-art technology.
As it is impossible to follow the continuing development of all materials (e.g.
lubricants in machine tools) which may interact with the controls and drives, it
cannot be completely ruled out that any reactions with the materials we use
might occur.
For this reason, before using the respective material a compatibility test has
to be carried out for new lubricants, cleaning agents etc. and our housings/
materials.
As standard, the motors are black (RAL9005).
According to standard, the components of the IndraDrive Mi range are tested
with voltage.
Testing
Voltage testing
Insulation resistance testing
Tab. 4-14: Applied standards
General data and specifications
IM V1
Flange mounting on drive
side of flange, drive side
bottom
Damage caused by penetration of fluids!
100% (EN 61800-5-1)
100% (EN 60204-1)
R911335703_Edition 04 Bosch Rexroth AG
59/407
IM V3
Flange mounting on drive
side of flange, drive side
top
Test rate