Panasonic LP-GS Series Operation Manual page 132

11 Graphic object
Graphic elements applied in AutoCAD LT and corresponding marking objects
• Depending on the drawing procedures and methods of the DXF data, minor conversion
errors can occur. As a result, some graphics marked by the laser marking system might
differ from the original graphics.
• If you reduce the graphic size, so that it is smaller than the original size, the difference
between the original graphic data and the marked data will increase. In particular for
curved lines, the differences will be more clearly visible.
• If graphic data that contains filling lines cannot properly be converted into marking data,
save the DXF file in a different file format.
• Unsupported elements in a DXF file cannot be marked.
The following tables show which elements are available for the marking process.
· valid (marking is possible)
Element
3DFACE
3DLINE
ARC
ATTDEF
ATTRIB
CIRCLE
DIMENSION
INSERT
LINE
POINT
POLYLINE
SEQEND
SHAPE
SOLID
132
DXF versions R12J, R13J, R14
Graphic name
3D face
3D line
Arc
Attribute definition
Attribute
Circle
Dimension
Insert graphic
Line
Point
2D polyline
3D polyline
Sequence end
Shape
2D paint
Validity Remark
–
–
·
–
–
·
–
·
·
–
Bold line is not supported.
·
–
· SEQEND in combination with
POLYLINE is available.
–
The SOLID element is converted
·
into outline and filling lines. The
filling lines are arranged either
horizontally or vertically.
If you set "Adjustment of size
and filling" to "ON" in the object
settings, you can change the filling
lines later.
ME-NAVIS2-OP-1