Set Laser Correction Parameters For Code Elements - Panasonic LP-GS Series Operation Manual

15 2D code object
(1) "Custom pattern" > "OFF"
(2) "Custom pattern" > "ON"
• "Character code":
This parameter becomes available if "Font" is set for "Filling pattern".
Select "Change" next to "Character code" to open the "Select 2D pattern code" dialog.
The pattern and character code of the 2D code pattern font is displayed.
‒ To select a pattern, click on it.
‒ Select "OK" to save your settings and close the dialog.
‒ To exit the dialog without changes, select "Cancel" or "X".
Related topics
Structure of a QR Code
Structure of a Data Matrix code
Specify quiet zone filling parameters for QR Code and Data Matrix

Set laser correction parameters for code elements

15.14.3 Set laser correction parameters for code elements
You can set the laser correction parameters and the number of overwritings for each code
element of QR Code and Data Matrix.
The laser correction parameters and the number of overwritings for a code element are
available if "Marking ON/OFF" or "Custom pattern" is set to "ON".
For QR Code, specify the laser correction parameters and the number of overwriting for the
following code elements: "Quiet zone outline", "Dark module", "Light module", "Alignment
pattern", "Finder pattern".
For Data Matrix, specify the laser correction parameters and the number of overwriting for
the following code elements: "Quiet zone outline", "Dark module", "Light module", "Border".
• To edit the parameters of a 2D code object, select the object in the object list or in the
marking image editor.
The parameters are displayed in the category below the object list.
178
(1)
If 0 (None) is set, the code element is not marked.
(page 158)
(page 159)
(2)
(page 179)
(page 178)
ME-NAVIS2-OP-1