Create An Arc - Panasonic LP-GS Series Operation Manual

8. To edit the parameters of the shape object, select the object in the object list or in the
marking image editor.
The parameters are displayed in the category below the object list.
Related topics
Create a line

Create an arc

Add or delete shapes in an existing shape object
Position or rotate a shape object
General object/object group parameters
Set laser correction parameters for a marking object
12.3 Create an arc
You can create different shapes such as a line, circle or an arc.
1.
2.
3.
4.
5.
6.
7.
The following drawings show how to set the parameters for an arc to achieve different
results.
ME-NAVIS2-OP-1
(page 135)
(page 137)
Select the "Graphic" tool in the ribbon.
Select "Shapes".
The setting dialog appears.
Select "Arc" for "Shape type".
To specify the position of the start and end point of the arc, enter values for "X-position
of start point [mm] ", "Y-position of start point [mm]", "X-position of end point [mm] "
and "Y-position of end point [mm] ".
You cannot set the same position for the start and end point.
Specify the radius of the arc under "Radius [mm]".
For "Direction", set the marking direction of the arc. Select "CCW" (counterclockwise)
or "CW" (clockwise).
For "Angle", set the angle of the arc. Select "<180°" or "≥180°".
(page 139)
(page 139)
(page 90)
(page 238)
12 Shape object
137