Stop Laser Radiation With The "Stop Laser" Button - Panasonic LP-GS Series Operation Manual

5. After the marking process is finished, lock the "Start marking" button. Select "Lock".
6. In the dialog, deselect the check box and select "OK".
7. To confirm, select "Yes".
"Start marking" button is disabled
Related topics
Perform marking in RUN mode
5.4

Stop laser radiation with the "Stop laser" button

Use the "Stop laser" button to terminate the laser radiation or disable the laser radiation
temporarily, for example when the workpiece is burning.
The "Stop laser" button is available in all screens except the "Startup" screen.
If you select the "Stop laser" button, the power supply of the oscillator is shut off via software.
To shut off the power supply of the oscillator via hardware, use the INTERLOCK inputs on
the TERMINAL connector of your laser marking system.
Select the "Stop laser" button to stop laser pumping and laser emission.
"Stop laser" button
The dialog for the laser stop alarm appears and the laser marking system executes the
following operations:
‒ Laser pumping turns off.
‒ Shutter closes.
‒ Alarm is activated.
Solve the safety problem, then select "Reset" to finish the laser stop status.
ME-NAVIS2-OP-1
5 Operation of the laser marking system
(page 51)
47