Panasonic LP-GS Series Operation Manual page 227

If the imagechecker does not respond within the set time, the warning E625 is output.
• "TIMING IN signal input":
If required, select "Enabled" to activate the timing input.
Use the TIMING IN input if you need to trigger operations of the laser marking system
and the imagechecker or code reader separately. This is necessary, for instance, when
the camera's or the code reader's field of view is distant from the marking position.
• "Application":
Select the desired application. Depending on the linked imagechecker, the application is
fixed.
"Image checking before marking": "Marking position correction" (fixed)
"Image checking after marking": "Code checking (PV230)", "Character checking (PV230)",
"Image capturing and inspection"
‒ DataMan, LP-ABR: Under "Image checking after marking", "Code checking" is set for
‒ PV200: Under "Image checking after marking", you must select "Image capturing and
‒ PV230: Under "Image checking after marking", you can set "Code checking
• "Object No. to check":
Enter the same object number as specified in "Object settings" for the marking object (bar
code, 2D code or character object).
This parameter is available if "Code checking (PV230)" or "Character checking (PV230)"
is set for "Application" under "Image checking after marking". Specify the object number
of the target object that should be checked.
If PV230/PV200 is set for "Model", the following parameters are available:
• "CDR checker No. set on PV":
Enter the same number as specified on PV230 ("Checker No." for code reader).
The parameter is available if "Code checking (PV230)" is set for "Application" under
"Image checking after marking".
• "Check human readable text":
Set "ON" to check the code symbol and the human readable text of a bar code or 2D
code object at the same time.
The parameter is available if "Code checking (PV230)" is set for "Application" under
"Image checking after marking".
• "OCR checker No. set on PV":
Enter the same number as specified on PV230 ("Checker No." for optical character
recognition).
The parameter is available if "Code checking (PV230)" or "Character checking (PV230)"
is set for "Application" under "Image checking after marking".
If "Application" > "Code checking (PV230)" is set: To check the code symbol and the
human readable text at the same time, specify "CDR checker No. set on PV" for the code
symbol and "OCR checker No. set on PV" for the human readable text.
ME-NAVIS2-OP-1
"Application".
inspection" for "Application".
(PV230)", "Character checking (PV230)" or "Image capturing and inspection". If
you set "Code checking (PV230)" for "Application", you can specify that the human
readable text is checked at the same time as the code symbol.
21 File setting
227