Siemens KION Service Manual page 42

Description of functions
3
Control panel
3 - 24
KION
Monitor
Siemens-Elema AB
User interface
20. Control panel
Mode selection, fresh gas supply, ventilation
parameters and alarms are set on the C
The C P also displays a number of set and
ONTROL ANEL
measured values.
A description of the control panel functionality can be
found in the KION / KION-i workstation – Operating
Manual.
The control panel housing contains the PC 1672
C P (including all displays) and all
ONTROL ANEL
potentiometers and switches.
A front panel, available in different language versions,
is mounted onto the control panel housing.
PC 1672 C P contains two exchangable
ONTROL ANEL
PROMs:
• PAN-PROM with the PAN software.
• ALA-PROM with the ALA software.
The main functions of the software are described in
chapter "Introduction" section "Electronic
structure".
21. KION Monitor
The KION Monitor is a Siemens patient monitor
equipped with different levels of functionality. It
shows clinical information parameters as configured
by the operator.
The KION Monitor used with the KION / KION-i
workstation is a Siemens patient monitor SC 7000,
SC 9000 or SC 9000XL.
When integrated with the KION / KION-i workstation,
the KION Monitor will show hemodynamic
parameters and:
• Ventilation parameters (curves and loops).
• Airway pressures.
• Fresh gas flow.
• Gas concentrations.
• Supply gas pressure.
The KION Monitor will also show technical informa-
tion from the KION / KION-i workstation such as
alarms and internal battery capacity.
Further, the KION Monitor is used during the semi-
automatic Pre-use Check and Calibration procedures
as well as during troubleshooting of the KION /
KION-i workstation.
For further information regarding the KION Monitor,
see the User's guide and the technical
documentation for Siemens Monitors.
KION / KION-i
P .
ONTROL ANEL
E382 E392E 061 01 02 02