ABB RMC-100 User Manual page 129

Figure 7-2: AI 1 set to voltage mode
4. Turn on the calibrator.
Click the Calibrate icon on the PCCU toolbar. The calibration Checks screen displays with a
5.
request to take an application out of hold
AGA3-2.
IMPORTANT NOTE: The calibration mode automatically places active measurement applications
on hold. This is not required for I/O calibration. The calibration navigation tree in
four AGA3 applications. The checkmark indicates that they are all in Hold mode. Pop-ups display to
remove applications from hold. Accept them all. These requests display one at a time until the last
application is out of hold.
(Figure 7-3). This example shows the request for
21 05 55 2MN A E | RM C-1 00 | 1 2 9
Figure 7-3 shows