Configure A Display Group - ABB RMC-100 User Manual

IMPORTANT NOTE: Assign only necessary applications. The system requires more storage for
more applications, groups and items.
5.4.3

Configure a display group

This procedure describes how to configure a non-default name for a display group, define the number
of group display items, and enable the group display on the LCD.
IMPORTANT NOTE: This procedure describes the configuration of the new group created in
section 5.4.1 Configure the number of display
The RMC stores the display group setup in a file, identified as the Group File Name
file name is Grp0000n.dg, where n is the number of the group. This number increases incrementally
for each additional group.
Figure 5-14 shows a display group created after the default group. The group file name is
Grp00002.dg and the default group description is Display Group 2. Change this to reflect the types of
values under that group. The group description identifies the group on the navigation tree.
Figure 5-14: Default Group setup
To change the new group's default configuration:
1. Click the Display Group number on the navigation tree to display the Group Setup tab. The
default configuration for the groups displays
groups. The existing factory default group is intact.
(Figure 5-15).
21 05 55 2MN A E | RM C-1 00 | 8 3
(Figure 5-14). This