ABB RMC-100 User Manual page 49

Figure 4-4: Factory default Ethernet configuration (PCCU Networking tab)
IMPORTANT NOTE: Initial communication with the RMC assumes that the factory default
configuration of the device is still intact. If unable to establish connection with Ethernet at first-time
connection, verify that Ethernet is enabled. To enable or verify the Ethernet configuration see
section 4.2.2.1.
Figure 4-5 illustrates Ethernet connections between a host system and the RMC. For first-time
communication, connect directly to any of the Ethernet ports or to the local network switch if one is
used. The example shows the RMC's default IP address (168.254.0.11). The laptop shows an example
of a compatible IP address. Use the default RMC IP address as the target address for connection setup
using PCCU.
Figure 4-5: First-time local connection with RMC-100 using Ethernet (2-port switch mode)
21 05 55 2MN A E | RM C-1 00 | 4 9