Enable Serial Port Switched Output Power; Configure Ethernet Network Communication - ABB RMC-100 User Manual

Figure 4-14: Serial port configuration for remote communication
4.4.2

Enable serial port switched output power

When powering external devices from the communication ports, use switched power to supply voltage
to those devices only when needed. Wire the external devices to the Sw VOUT pins to support this
feature.
To enable switched power:
1. Click I/O System on the navigation tree.
2. Click Auxiliary I/O on the navigation tree.
3. Click Digital (Figure
Figure 4-15: Enable communication switched power
4. Click the Value cell on the Switched VOUT line to On for the correct port.
Switched VOUT 1 for COMM 1
•
Switched VOUT 2 for COMM 2
•
5. Click Send.
4.5

Configure Ethernet network communication

To configure the RMC for network communication, determine the required network topology first. If
the RMC is used in conjunction with an XIO, review additional configuration options and connection
scenarios in the Network Communication Guide (See
5 6 | R MC-1 00 | 2 10 55 5 2MN A E
4-15). The Digital tab displays.
Additional information for a link to this guide).