Local Access To Rmc By Host (Connections) - ABB RMC-100 User Manual

Figure 4-17: Remote access by host to an RMC-100 in 2-port switch mode
4.6.2

Local access to RMC by host (connections)

Figure 4-18 shows local access with an RMC that has been configured for connection to the customer
wide area network. Local access to the RMC using Ethernet does not require disconnecting the RMC
from the network. You can connect to the unused Ethernet port while leaving the connection to the
network intact.
IMPORTANT NOTE: When the RMC is configured for network connection, the default IP address is
no longer available. The laptop must have an IP address compatible with the new non-default
address assigned to the RMC.
21 05 55 2MN A E | RM C-1 00 | 5 9