Fujitsu Eternus2000 Manual page 153

3
Attach the bracket to the rack.
M5 screws
The vertical positions of the four M5 bracket screws (and holders) are determined relative to the
drive enclosure's bottom base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
4
Tighten the screws that were adjusted in
5
Remove the front cover of the drive enclosure.
Refer to
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Distance Between Front and Rear Rack Pillars
M4 screws
• If the rack pillars have square (approx. 9mm) holes, screw hold-
Point
ers will need to be used when attaching the brackets.
• Attach the left and right brackets as far apart as possible, to
provide maximum mounting width.
Bracket L
Screw holders
(Front rack pillars)
M5 screws
(Front rack pillars)
9th position
(M5 screws)
1st position
(M5 screws)
Drive enclosure base line
Brackets
"2.2.3 Attaching and Removing the Front Cover"
Copyright 2009 FUJITSU LIMITED
Chapter 5 Installing Optional Products
Bracket L
Screw holders
(Rear rack pillars)
Bracket R
Screw holders
(Rear rack pillars)
5th position
(M5 screws)
2nd position
(M5 screws)
Drive enclosure base line
Step 2.
for the appropriate procedure.
M5 screws
M5 screws
Screw holders
Brackets
5
129