Eternus2000 Setup - Fujitsu Eternus2000 Manual

4.3

ETERNUS2000 Setup

This section explains how to setup the ETERNUS2000 using a PC.
Prepare the following before setting up the ETERNUS2000.
Filling in the Network Settings Label
Fill in the IP address and subnet mask fields on the Network Setting label and attach it on rear upper cen-
tral label plate.
Network Settings label
IP address of MNT port
IP address of FST
Subnet Mask
IP address of RMT port
Plate
Tag
Pull out the plate while holding the tag.
Figure 4.5
The IP address for the PC used by the maintenance engineer during maintenance is also required. Acquire
the IP address and note it on the Network Settings label.
Table 4.3
IP address of MNT port
IP address of FST
Subnet Mask
IP address of RMT port
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Network Setting
: . . .
: . . .
: . . .
: . . .
Network Settings label
Network Settings label fields
Items
IP address of the device MNT port
IP address of PC (FST) used by maintenance engineer
Subnet mask of network connected
IP address of the device RMT port
Copyright 2009 FUJITSU LIMITED
Label Holder
Value
Chapter 4 Setup
4
87