Fujitsu Eternus2000 Manual page 80

3.2 Rack Installation
3
4
56
The four M6 screw positions for the brackets and holders are determined relative to the AC outlet
box base line.
The M6 screws should be inserted in the 1st and 3rd holes above the base line.
(Rear rack pillers)
3rd position
(M6 screws)
1st position
(M6 screws)
Base line of
AC outlet box
Brackets
Mount the AC outlet box in the rack.
Fasten the AC outlet box to the bracket with two M3 screws.
M3
screws
(Rear rack pillars)
M3
screws
Attach the blind cover plate to the front side of the rack.
The blind cover plate should be attached at the same height as the AC outlet box.
1 Attach nuts to the rack pillars.
When the holes in the rack pillars are circle, use the U-type
Point
chimney nuts to attach. When the holes in the rack pillars are
square, use the M5 cage nuts to attach.
The nuts should be inserted in the 2nd holes above the AC outlet boxes base line.
The following shows the example when the holes in the rack pillars are square.
(Front rack pillars)
2nd position
(M5 cage nuts)
Base line of AC outlet boxes
Copyright 2009 FUJITSU LIMITED
ETERNUS2000 disk storage system User Guide P3AM-2512-03EN