Ac Automatic Linkage Mode Setup - Fujitsu Eternus2000 Manual

4.3 ETERNUS2000 Setup
4.3.3

AC Automatic Linkage Mode Setup

When AC automatic linkage mode is enabled, the ETERNUS2000 is automatically turned on when the
power supply recovers after a power failure. This section explains how to setup the AC automatic linkage
mode.
1
2
3
106
Remove the front cover of the ETERNUS2000.
For details on how to remove the front cover, refer to
Cover" (page 40).
Turn the AUTO POWER switch to ON.
AUTO POWER
switch
• Make sure to set the AUTO POWER switch of the controller
IMPORTANT
• If AC power is being supplied, turning the AUTO POWER
• If the AUTO POWER switch is the ON position, connecting
Attach the front cover.
For details on how to attach the front cover, refer to
Cover" (page 40).
Copyright 2009 FUJITSU LIMITED
"2.2.3 Attaching and Removing the Front
enclosure and the drive enclosure to the same setting.
switch to the ON position will cause the ETERNUS2000 to
turn on.
the power cord to the outlet will cause the ETERNUS2000 to
turn on.
"2.2.3 Attaching and Removing the Front
ETERNUS2000 disk storage system User Guide P3AM-2512-03EN