Post Start-Of-Operation Changes To The Configuration; When Replacing The Fibre Channel Card - Fujitsu Eternus2000 Manual

6.4 Post Start-of-Operation Changes to the Configuration

6.4 Post Start-of-Operation Changes to the Configuration
This section explains the procedure to change the configuration after starting the system operation, using
the following example. Refer to necessary part of this section.
•
•
6.4.1

When Replacing the Fibre Channel Card

The following explains how to replace a failed Fibre Channel card.
Note that this is only an overview of the replacement procedure. Refer to the relevant manuals for more
details.
If ETERNUS SF Storage Cruiser is installed, refer to the ETERNUS SF Storage Cruiser manuals and
check necessary settings.
The procedure to replace a Fibre Channel card is as follows:
Procedure
1
2
3
4
150
When Replacing the Fibre Channel Card
When Replacing the LAN Card / iSCSI HBA
Do
CAUTION
• When you detect abnormality of the ETERNUS2000, Contact your
maintenance engineer immediately.
• When changing the configuration, record the change by using the
memo page in "ETERNUS8000, ETERNUS4000, ETERNUS2000
Server Connection Guide" and so on.
• User guide for Fibre Channel card
Refer
• "ETERNUS8000, ETERNUS4000, ETERNUS2000 Server Connec-
tion Guide (Fibre Channel)"
• "ETERNUS2000 ETERNUSmgr User Guide -Settings/Maintenance-"
ETERNUS SF Storage Cruiser manuals
Refer
Before applying this procedure, check and record the WWN (World Wide Name)
or host affinity of the Fibre Channel card to be replaced.
Turn off the server for which the Fibre Channel Card is to be replaced.
Replace the Fibre Channel card.
For details of the replacement procedure, refer to the user guide attached with the Fibre Channel
card.
Delete the setting of WWN or host affinity set to the uninstalled Fibre Channel
card.
ETERNUS2000 disk storage system User Guide
Copyright 2009 FUJITSU LIMITED
P3AM-2512-03EN