Fujitsu Eternus2000 Manual page 77

1
Refer to "ETERNUS2000 models 100 and 200 disk storage system Package
Contents" to confirm there are no missing parts for the rack mount kit.
2
Adjust the bracket sizes to fit the rack.
Reposition the M4 screws to adjust the length of the brackets to match the distance between the
front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the bracket must be
attached to the rack before they can be completely tightened.
3
Attach the bracket to the rack.
M5 screws
The four M5 screw positions for the brackets and holders are determined relative to the AC outlet
box base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Distance Between Front and Rear Rack Pillars
M4 screws
• When the holes in the rack pillars are square, use the screw
Point
holders to attach.
• Attach brackets to the outside as far apart as possible.
Bracket L
Screw holders
(Front rack pillars)
M5 screws
(Front rack pillars)
3rd position
(M5 screws)
1st position
(M5 screws)
Base line of
controller enclosure
Brackets
Copyright 2009 FUJITSU LIMITED
Bracket L
Screw holders
(Rear rack pillars)
Bracket R
Screw holders
(Rear rack pillars)
3rd position
(M5 screws)
1st position
(M5 screws)
Base line of
controller enclosure
Brackets
Chapter 3 Installation
M5 screws
M5 screws
Screw holders
3
53