Rack Installation - Fujitsu Eternus2000 Manual

3.2 Rack Installation

3.2 Rack Installation
This section describes the procedure for installing the ETERNUS2000 in a rack.
Make sure to check "ETERNUS2000 models 100 and 200 disk storage system Safety Precautions" before
installation. Also refer to the manual provided with racks.
Rack installation example
Install the controller enclosure, drive enclosures and the AC outlet box in the following layout.
Drive enclosure 9
Drive enclosure 8
Drive enclosure 7
Drive enclosure 6
Drive enclosure 5
Drive enclosure 4
Drive enclosure 3
Drive enclosure 2
Drive enclosure 1
Controller enclosure
*1:
48
Do
CAUTION
• Before starting, make sure to attach a wrist strap or touch the metal
frame of the device to eliminate static electricity. Failure to discharge
static electricity may cause device failure.
• If components are attached or removed in a way other as described
herein, damage and/or device failure or electrical shock may occur.
• This device contains delicate components, and should be handled gen-
tly. Do not drop or knock the device against the rack when installing it.
• If no other components are installed, attach the blind panels provided
with the rack.
AC outlet box (4U) (*1)
AC outlet box (4U) (*1)
This is an example for installing two 4U size AC outlet boxes. A maximum of five AC outlet boxes can be
installed for a 1U size AC outlet box.
ETERNUS2000 disk storage system User Guide
Copyright 2009 FUJITSU LIMITED
P3AM-2512-03EN