Hitachi Compute Blade 500 Series User Manual page 107

Items
-: unusable
Notes:
1 The MAC address is not taken over when switching N+M.
.
Setting standby server blade
• If the management module firmware version is A0135 or earlier, you
need to set the following items on the standby server blade in advance.
1.LPAR manager firmware selection
Assign LPAR manager on Web console.
2.Logical Partitioning
Set Enabled on Web console.
3.Initial settings
Set the following items on Web console.
IP address for LPAR manager
¢
Subnet Mask
¢
Default gateway
¢
VNIC System No.
¢
Time Zone
¢
For details about LPAR manager firmware selection, logical partitioning,
and LPAR manager initial settings, see the Hitachi Compute Blade 500
series Server Blade Setup Guide.
Registering standby server blade set to boot in LP mode in N+M cold
standby
• Register and unregister the standby server blade set to boot in LP mode
in N+M cold standby according to the following procedures.
[Registering a standby server blade]
¢
1. Set the Operating mode to LP mode for a server blade, and register
the server blade in the standby pool. Then power on the server blade.
2. Confirm that "Initializing LP" is disappeared on the LPAR manager
screen or the web console.
3. Shut down the LPAR manager to power off the server blade.
4. Register the server blade as the standby server blade, and
configure the N+M cold standby.
[Unregistering a standby server blade]
¢
1. Unregister a standby server blade from the standby pool.
2. Set the Operating mode to LP mode for the server blade, and then
power on the server blade.
3. Confirm that "Initializing LP" is disappeared on the LPAR manager
screen or the web console.
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
original MAC
High Reliability Functions
additional MAC
3-7