Hitachi Compute Blade 500 Series User Manual page 338

Message Content
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
9-4
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Error: Could not load loader image from Management
Module, error code:[0xXXXX].
Please check network connection with management
module and network
XXXX:EFI Status Code
Check there are not any problems in a setup of a network, a LAN
switch and a connection.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Error: Could not set VLAN ID[0xXXXX],Port[0xYY],error
ZZZZ:EFI Status Code
Assignment of Tag of VLAN ID failed.
Check VLAN ID is set as a value 0 to 4094.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Error: Could not start loader.(XXXX)[0xYYYY]
LoadImage Error (The error of the program image deployed
Handle protocol Error (EFI inside error)
Start Image Error (LP loader Executing Error)
YYYY:EFI Status Code
Booting the LPAR manager loader failed.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Error: Ipmi driver initialization failed, error code:[0xXXXX].
XXXX:EFI Status Code
An error was detected before IPMI command issue.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Error: Network error occurred,retry after a few seconds.
(PortX,Cmd:[0xXXXX],detected code[0xXXXX],error
Because a network error occurred, communication with the
management path will be retried at communication port PortX
(MgmtX).
Check there are not any problems in a setup of a network, a LAN
switch and a connection.
Messages
code:[0xZZZZ].
XXXX:VLAN ID
YY:Port NO.
XXXX:cause
on the memory)
code[0xXXXX])