Hitachi Compute Blade 500 Series User Manual page 207

Key
Displays the PCI device mapping
information.
Displays the VLAN ID assignment and
promiscuous mode setting list on a sub-
screen in the VNIC Assignment screen.
Deletes a user from user authentication.
[F3] Activates (powers on) an LPAR.
Changes the password used for user
authentication.
[F4] Deactivates (powers off) an LPAR.
[F5] Reactivates (restarts) an LPAR.
Switches USB devices assignment.
Sets the promiscuous mode.
[F6] Adds (defines) an LPAR.
Change USB auto attach settings
Changes the MAC address.
Changes LPAR manager system time
[F7] Deletes an LPAR.
Sets the VLAN mode.
Changes LPAR manager system time zone
[F8] Switches to display of a guest screen.
Sets the packet filter for communication
between LPARs.
[F9] Saves the LPAR manager configuration to
the non-volatile storage in the Switch and
Management Module.
[LPAR manager firmware version 01-9X or
later]
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Operation / Roll
Operation Performing
Screen
PCI Device Information
VNIC Assignment
System Configuration
LPAR manager Menu
Logical Partition
Configuration
System Configuration
LPAR manager Menu
Logical Partition
Configuration
LPAR manager Menu
Logical Partition
Configuration
PCI Device Assignment
VNIC Assignment
LPAR manager Menu
Logical Partition
Configuration
PCI Device Assignment
VNIC Assignment
Date and Time
LPAR manager Menu
Logical Partition
Configuration
VNIC Assignment
Date and Time
LPAR manager Menu
Logical Partition
Configuration
VNIC Assignment
LPAR manager Menu
Logical Partition
Configuration
VNIC Assignment
7-3