Hitachi Compute Blade 500 Series User Manual page 167
Logical partitioning manager
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
11
Enter drvcfg [driver handle], then Search the controller handle.
.
In this example, [84] is controller handle.
Tip:
•
Multiple results are displayed when multiple FC ports are allocated to
LPAR. Any displayed controller handle can be selected.
12
Enter drvcfg –s [driver handle] and [controller handle then hfccfg >
.
prompt is shown.
13
Enter select command then select FC adapter which is using for a booting.
.
In this example, select [1]
14
Enter Set command, andthen Set items are as follows. Set the other
.
items according to your environment, if required.
– Boot Function = Enabled
– Select Boot Device = Enabled
– Set the WWPN and LUN No. of port which are used on the target
external disk array equipment to the Boot Device List.UsuallyList. Usually
LU0 is considered as the boot LU, therefore setup 0.
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Setup of LPAR manager
5-37
Advertisement
Table of Contents
