Hitachi Compute Blade 500 Series User Manual page 363
Logical partitioning manager
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LP detected MCKINT for Shared FC at expansion card.
A temporary fault in shared FC was detected.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP detected MCKINT for Shared FC.
A temporary fault in shared FC was detected.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP detected network communication error at SC Manager
A communication error occurred between LPAR manager and SC/
BSM.
Check the connection between LPAR manager and SC/BSM. If you
cannot remove this error, contact the reseller from which you
purchased this equipment or consult maintenance personnel.
LP detected PCI bus error for Shared FC at expansion card.
A PCI bus fault in shared FC was detected.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP detected unsupported version of firmware on a NIC
Unsupported firmware version was detected on a NIC device.
Check the NIC firmware version is supported or not. If this action
takes no effect, contact the reseller from which you purchased
this equipment or consult maintenance personnel.
LP failed to get the firmware version on a NIC device.
Retrieving the firmware version from a NIC device failed.
Reboot the LPAR manager. If this LP system log is collected after
rebooting, contact the reseller from which you purchased this
equipment or consult maintenance personnel.
LP failed to have SR-IOV device enabled.
Detects different SR-IOV settings (enable/disable) for two ports of
the same controller of PCI device.
Check the SR-IOV settings of PCI device, or confirm that
"Personality" is set to NIC mode.
Messages
access.
device.
9-29
Advertisement
Table of Contents
