Hitachi Compute Blade 500 Series User Manual page 250

The following figure is an example for the list of VLAN ID assignment and
Promiscuous Mode settings.
The following table shows the list of VLAN ID assignment and Promiscuous
Mode settings.
No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
7-46
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Figure 7-15 Promiscuous Mode Detail Setting Screen
Table 7-19 Details of Promiscuous Mode Setting Screen
Item
Segment Displays the network segment identifier to show the list.
LPAR# Displays the LPAR number to set the network identifier shown in
(1) from smaller to larger numbers.
VNIC# Displays the virtual NIC number corresponding to the LPAR
shown in (2) from smaller to larger numbers.
Prm Displays the promiscuous mode defined in the virtual NIC
shown in (3).
Mode Displays the VLAN mode defined in the virtual NIC shown in (3).
VLAN ID Displays VLAN IDs defined in the virtual NIC shown in (3) from
smaller to larger numbers. VLAN IDs are displayed in two rows
when the assigned VLAN IDs are 9 or more (up to 16). Only
'ALL' is displayed when the VLAN ID is assigned ALL.
TXRATE [LPAR manager firmware version 01-9X or later]
ASSIGN
When VF NIC is assigned, an amount of limited transmission
bandwidth assigned LPAR is displayed.
ACT [LPAR manager firmware version 01-9X or later]
When VF NIC is assigned, an amount of limited transmission
bandwidth that LPAR uses (Active state) is displayed.
Operation by LPAR manager Screen
Description