Hitachi Compute Blade 500 Series User Manual page 368

Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
9-34
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LP detected failed SR-IOV device was assigned to LPAR.
LPAR manager detected that the LPAR assigning the isolated PCI
device was activated.
Since the PCI device is in an error condition, it cannot be used on
LPAR.
When the state of a PCI device is not recovered automatically,
perform the ForceRecovery operation to recover the isolated
state.
Start the guest OS after the PCI device recovery, and the PCI
device can be used again.
LP detected initial parameter error.
Incorrect data of the initial parameter file was detected.
Check the settings on the System Configuration screen.
LP detected PCI bus error for Shared FC.
A PCI bus fault in shared FC was detected.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP detected PCI dev assign error.
LPAR manager detected invalid PCI device assignment.
Re-allocate the PCI device on the PCI Device Assign screen. If this
LP System Logs is re-obtained, contact the reseller from which
you purchased this equipment or consult maintenance personnel.
LP detected too many physical CPUs, some CPUs are
Ignoring some Processors due to those Processors installed
beyond the maximum number of them LPAR manager can
recognize.
Contact your reseller or maintenance personnel.
LP dump generation failed.
The LPAR manager dump failed to be obtained.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
The LPAR manager dump was lost.
Messages
ignored.
LP dump is lost.