Hitachi Compute Blade 500 Series User Manual page 265

The following table describes each item on this screen.
Table 7-25 Details of the LPAR manager System Configuration Screen
No. Item
(1) LP ID Sets the ID that identifies LPAR manager
Numbers, in which periods are omitted
from the LP IP Address, are reflected as
the initial value following "LP_".
(2) LP IP Address Display LP IP Address
LP IP Address which is set as the
management module is reflected.
(3) Subnet Mask Display Subnet Mask
Subnet Mask which is set as the
management module is reflected.
(4) Default Sets the IP address of the Default
Gateway Gateway.
Default Gateway which is set as the
management module is reflected.
(5) SVP IP Set the IP Address.
Address
SVP IP Address which is set as the
management module is reflected.
(6) BSM1~4 Sets the IP addresses for the
ServerConductor/Blade Server Manager
IP Address
(BSM).
When LPAR manager is started, the
System Manager 1~4 IP Addresses,
which are set to the management
module, are applied as the initial values.
(7) BSM1~4 Sets the alert port numbers for the
ServerConductor/Blade Server Manager
Alert Port
(BSM).
When LPAR manager is started, the
System Manager 1~4 Alert Ports, which
are set to the management module, are
applied as initial values. (Recommended
setting)
(8) Management Displays the PCI device of the NIC used
Path for the management path.
Default: network segment 1a and 1b are
set as management paths.
The management path is a path used for
communication to the management
server, where SC/ BSM/HvmSh
commands operate, by LPAR manager.
This item is not displayed in the firmware
combinations that support change of
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Description
Supported
Default LPAR
Value manager
Version
LP_XXXX 01-0X~
- 01-0X~
- 01-0X~
- 01-0X~
- 01-0X~
- 01-0X~
- 01-0X~
Default 01-0X~
7-61