Hitachi Compute Blade 500 Series User Manual page 350

Message Content
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
LPAR manager
operation
What to do
Message Content
Explanation
9-16
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
IP address of NTP server is needed.
Set the IP address of a NTP server to NTP Server 1 or NTP server
2.
LPAR activation failed.
The LPAR cannot be activated.
Aborts LPAR activation.
Check that LP system logs showing failure are collected or not. If
this action takes no effect, contact the reseller from which you
purchased this equipment or consult maintenance personnel.
LPAR activation failed(Insufficient LPAR memory(System
LPAR run out of memory size that can be used (the allocated
memory size for the LPAR – the used memory size for the system
unit).
Aborts LPAR activation.
Increase the allocated memory size for LPAR and then activate
the LPAR increase memory size.
LPAR corrupted in a LPAR Migration exist,
Please try again after recovering the LPAR.
Since there is a LPAR which has failed due to LPAR migration, it
cannot be operated.
Aborts the specified process.
Retry the specified operation to the LPAR after recovering the
LPAR Migration.
LPAR deactivation failed.
The LPAR cannot be deactivated.
Aborts LPAR deactivation.
Check that LP system logs showing failure are collected or not. If
this action takes no effect, contact the reseller from which you
purchased this equipment or consult maintenance personnel.
The target LPAR failed to restart.
Messages
Used:xxMB))
LPAR start failed.