Hitachi Compute Blade 500 Series User Manual page 340

Message Content
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
9-6
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LP-Loader could not update OEM FRU
There is a possibility that the BMC error occurred or FRU data is
damaged.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP-Loader detected configuration error in management
path portX, [Code:X SlotType:XX BladeNo:XX SlotNo:XX
A configuration error in the management path was detected.
Check whether there are any problems in the management path
configuration and settings.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP-Loader detected an unsupported NIC. (Bus:0xXX, Dev:
0xYY, Fnc:0xZZ) Please Power Off Partition.
YY: Device number
ZZ: Function Number
An unsupported NIC is detected. So, the LPAR manager boot is
suppressed.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP Loader detected Emulex Multi Channel mode (Bus:0xXX,
Dev:0xYY, Fnc:0xZZ), which is not supported. Please
disable Emulex Multi Channel mode.
YY: Device number
ZZ: Function Number
LPAR manager cannot boot due to the Enabled multiple channel
support of Emulex NIC.
Set "Multichannel Support" as <Disabled> in Emulex PXESelect
Utility.
See the Hitachi Compute Blade Emulex Adapter User's Guide for
Hardware for setting it.
However, it cannot be changed in LP mode. If necessary, change
it in Basic mode.
Messages
PortNo:XX].
XX: Bus number
XX: Bus number