Hitachi Compute Blade 500 Series User Manual page 317

No. Item
control allows a tolerance of 1% for each
unit of processor-time. A shared mode
LPAR is allocated a maximum processor-
time that is 1% greater than the total
service time of the physical processors
assigned to it, and this value may exceed
100%.
(11) Dsp(%) Displays the proportion of the LPAR's
service time to the total service time of all
shared mode physical processors when the
LPAR is in shared mode.
This value is obtained by the following
formula.
Dsp(%) = the LPAR's run time ÷ service
time of all shared physical processors
running properly x 100
Grp (ALL): "---" is displayed
Displays "---" when the LPAR is in the
dedicated mode.
(12) PC Displays the enabled/disabled status of the
Processor Capping function as configured in
the LPAR Configuration screen.
Y: Processor Capping is enabled in shared
mode.
N: Processor Capping is disabled in shared
mode.
*: Processor Capping is ignored in
dedicated mode.
-: The LPAR has not been activated.
(13) Sampling Sets the refresh rate of the screen in units
time of seconds.
The default setting is 5 seconds, but this
can be changed to anything between 1 and
60.
(14) Proc Displays the number of physical processors
assigned to the dedicated mode and the
shared mode.
D: The number of physical processors
assigned to the LPAR in the dedicated
mode.
Format is n or m.
n: Total number of physical processors
assigned to the LPAR running properly in
the dedicated mode
m: Total number of all processors assigned
to LPAR in the dedicated mode.
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Description
Supported
Default LPAR
Value manager
Version
--- 01-0X~
- 01-0X~
5 01-0X~
--- 01-0X~
7-113