Toshiba GRL100-701B Instruction Manual page 42

Setting depending on communication mode
The setting depending on communication mode is shown in the following table.
Setting
Communication COMMODE
mode
GPS backup GPSBAK
mode
MODE2B shifted AUTO2B
automatically
Phase difference SRCθ
check
Terminal TERM
application
Relay address RYIDSV
monitoring
Multi-phase Autoreclose
autoreclosing mode
Open terminal OTD
detection
Zero-phase DIFG
current differential
Out-of-step OST
tripping
Fault locator FL
Remote RDIF
differential trip
--: don't care.
Terminal application
In A-MODE and B-MODE, anyone of 2TERM, 3TERM or DUAL can be selected. In
GPS-MODE, however, DUAL cannot be selected.
Multi-phase autoreclosing
To apply the multi-phase autoreclosing with MPAR2 or MPAR3, the relay address monitoring
RYIDSV in B-MODE and GPS-MODE must be set to "OFF". When the RYIDSV=OFF, CBLS
(CBDS) condition is sent.
If shared with the relay address monitoring, the bits for CBLS condition can be assigned instead
of the bits for DIFG or OST/FL by PLC function when DIFG or OST/FL is not used.
Automatic open terminal detection OTD
In B-MODE and GPS-MODE, the RYIDSV=OFF setting for relay address monitoring is
required to use the open terminal detection function (OTD=On).
If shared with the relay address monitoring, the following methods can be applied:
(1) Only one bit with open terminal condition instead of CBLS condition can be sent by
sub-communication bit.
(2) If DIFG or OST/FL is not used, the bits for CBLS condition can be assigned instead of the
bits for DIFG or OST/FL by PLC function.
The open terminal detection in B-MODE and GPS-MODE do not automatically change
A-MODE B-MODE
Must select "A" of Must select "B" of
A/B/GPS A/B/GPS
-- --
-- --
-- --
2TERM/3TERM/ 2TERM/3TERM/
DUAL DUAL
-- On/Off
MPAR2/MPAR3 MPAR2/MPAR3
On/Off On/Off
On/Off On/Off
Trip/BO/Off Trip/BO/Off
On/Off On/Off
-- On/Off
 41 
GPS-MODE Default setting
Must select "GPS" B
of A/B/GPS
On/Off On
On/Off Off
Disable/I I
2TERM/3TERM 2TERM
On/Off On
MPAR2/MPAR3 SPAR&TPAR
On/Off Off
On/Off On
Trip/BO/Off Off
On/Off On
On/Off On
6 F 2 S 0 8 5 0
Remarks
Available for only
2TERM setting
For 3 terminal
application model
RYIDSV=Off is
required
Available for 3TERM
application